Valve amplifier  Bosch Rexroth R900903754
Valve amplifier  Bosch Rexroth R900903754

We are not the manufacturer, authorised distributor or authorised representative of the Bosch Rexroth brand Worldwide. The private labels and part numbers shown on this website are the property of their respective owners.

R900903754 Bosch Rexroth Valve amplifier

Manufacturer

Bosch Rexroth

Country

Germany

Part number

R900903754

Category

Valve amplifiers

Type

Valve amplifier

Stock availability:

On request

Price: On request

Order

Several positions are needed?

Send your request on email:

Worldwide delivery services:
fedex dhl ups
Ways of payment:
wire transfer paypal

Specifications R900903754

The valve amplifiers operate with a push-pull output stage with bipolar transistors. The output of this output stage can be connected or disconnected by means of an enable circuit (relay K2). The enable is indicated by the LED "H2" on the front plate being illuminated. The switching voltage of all relays is defined by means of jumpers J12 and J13 to either 0 V or +U B (factory +U B ). The output stage consists of an I controller with connected dither signal generator. The amplitude of the dither signal is set by means of R7. The pre-stage (current command value) is controlled via a PD controller. The actual current value returned is simultaneously indicated by the instrument on the front plate. For control, the following applies: For valve type 2WRC:
A positive command value at connection 30a results in the main stage opening and a flow from A to B or B to A. For valve type 3WRC:
A positive command value at connection 30a results in a flow from P to A in the main stage.
A negative command value at connection 30a results in a flow from A to T in the main stage. The oscillator/demodulator senses the control spool position. It is designed as pluggable board the parameters of which are adapted to the respective valve type. The PD controller is supplied the position command value and the position command value and the actual position value with the D share of the controller only affecting the actual value (velocity feedback). The zero point can be set via R3 (NP) from the front plate. The required symmetric operating voltage +U B is protected against reversed polarity. If the board is not equipped with any voltage regulators for supply of the controller and position transducer electronics, an additional stabilized auxiliary voltage ±U M is required. The auxiliary voltage port is protected against reversed polarity up to a maximum current of 1 A. As an option, the amplifier can be equipped with a PID controller (D share only affects the actual value) with a switchable PI share and a backup relay with potential-free changeover contact. This controller can be used to superimpose a further control loop (e.g. for drive control). The P and D share can be set at the front plate. The controller switching status is indicated by the LED "H1", the relay at LED "H3" (LEDs illuminated if relays are applied). The PID controller fitting is customer-specific and therefore has to be specified in the order in plain text. These amplifiers receive a special type designation upon delivery. The backup relay is loadable up to 28 V and 0.5 A.

Features R900903754

  • Component series 1X
  • Analog, Euro-card format
  • For valves: .WRC